I sublimated a product, but it didn't turn out right

 

In the event that you have tried to sublimate any product and the design has been left with little ink or faded, even if it is only at the bottom; try to accommodate the product in the center of the resistance and increase the pressure of the machine a little.

It is recommended before removing the paper after sublimating a product, first lift the corners a little to check if the design was well stamped. If not, do not remove the paper and try sublimating it again. It is important that the paper does not move at all and remains in exactly the same place as before, this will prevent the design from being run in the second sublimation.

If the problem persists or other abnormality occurs in the product, contact the email animationprint@gmail.com


Older Post Newer Post